- Installation size: NEMA17/flange dimension 42mm
- Protection class: Motor housing IP65 (shaft seal IP52)
- Holding torque: 0.50Nm
- Rated current: 1.80A
- Motor connection: Metric M12 connector
drylin® E stepper motor with connector, NEMA 17
drylin® E stepper motor with connector, NEMA 17
NEMA17: Small, but lots of powerThis little motor has impressive torque and high RPMs. Reliable operation with quick movements of low loads.
Stepper motors from igus® are a good supplement to drylin® linear axes. They are characterised by their cost-effectiveness, their precision and easy control. They work reliably under the most varied environmental conditions (depending on the selected class of protection IP). The igus® stepper motors can be connected to the most common motor controls using standardised electrical connection.
The connector interface provides a high IP65 protection level (IP: International Protection). The higher the IP rating, the better the motor is protected from the ingress of dirt and water.
drylin® D1 motor control system for stepper, DC and EC/BLDC motors
- A wide range of automation tasks by simple parameterisation, no programming necessary
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
You can find all relevant documents in the downloads below.
TEST BEFORE INVEST - Try out the motor control system here with the online simulation before you buy it
Preis:Upon request
igus-icon-lieferzeit
Delivery time on request
drylin® D2 motor control system for stepper, DC and EC/BLDC motors
- A wide range of automation tasks by simple parameterisation, no programming necessary
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
You can find all relevant documents in the downloads below.
Further information on dryve D1 info page
Preis:Upon request
igus-icon-lieferzeit
Ready for shipment within 24 - 48 hours
igus-icon-3arrow
drylin® motor expert
Purchase advice for electric motors
igus-icon-3arrow
drylin® E dryve Experience
With the dryve Experience, we would like to support you in the design, commissioning and also in the elimination of problems. You will find detailed tutorial videos of all functionalities for the respective motor control.
igus-icon-3arrow
