- Installation size: NEMA24/flange dimension 60mm
- Protection class: Motor housing IP65 (shaft seal IP52)
- Holding torque: 3.50Nm
- Nominal current: 4.20A
- Motor connection: stranded wires with JST connector
drylin® E stepper motor, stranded wires with JST connector, NEMA24
drylin® E stepper motor, stranded wires with JST connector, NEMA24
NEMA24: power motor in medium installation sizeA development extension of the typical NEMA24 with nearly twice the torque. The assembly dimensions are identical to the NEMA24, allowing many applications.
Stepper motors from igus® are a good supplement to drylin® linear axes. They are characterised by their cost-effectiveness, precision and easy control. They work reliably under the most varied environmental conditions (depending on the selected class of protection IP). The igus® stepper motors can be connected to the most common motor controls using standardised electrical connection.
Motors with stranded wires are the least expensive and the most common stepper motors. The connecting wires for this type exit from the housing and will be connected with a JST connector. They are usually installed in machines and equipment that have an additional housing or are used in clean environments.
drylin® D1 motor control system for stepper, DC and EC/BLDC motors
- A wide range of automation tasks by simple parameterisation, no programming necessary
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
You can find all relevant documents in the downloads below.
TEST BEFORE INVEST - Try out the motor control system here with the online simulation before you buy it
Preis:Upon request
igus-icon-lieferzeit
Delivery time on request
drylin® D2 motor control system for stepper, DC and EC/BLDC motors
- A wide range of automation tasks by simple parameterisation, no programming necessary
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
You can find all relevant documents in the downloads below.
Further information on dryve D1 info page
Preis:MYR 2,590.79/Pc.
igus-icon-lieferzeit
Ready for shipment within 24 - 48 hours
